HDPE film grades: H5604F (SCG) vs HD7000F (PTT GC)
H5604F and HD7000F are two popular Southeast Asian HDPE grades for thin film – carrier bags and HM film. Both have MI 0.04 and look very close on paper.
Updated: 17 Nov 2026 · Thien An Plastics
TDS comparison
| Property | H5604F SCG Chemicals | HD7000F PTT Global Chemical (InnoPlus) |
|---|---|---|
| Melt flow (190 °C/2.16 kg) | 0.04 g/10 min | 0.04 g/10 min |
| Density | 0.954 g/cm³ | 0.956 g/cm³ |
| Melting point | 131 °C | — |
| Vicat softening point | 124 °C | 125 °C |
| ESCR | >1000 h | > 1000 h |
| Dart impact | 139 g | — |
| Tensile strength at yield | — | 300 kg/cm² (≈29.4 MPa) |
| Elongation at break | — | 820 % |
Typical values from each producer's TDS, for reference only, not guaranteed specifications. "—" means not stated on the TDS. Values marked "≈" are unit conversions by Thien An for easier comparison.
Key differences
- Same MI 0.04 (190 °C/2.16 kg), density 0.954 and 0.956, Vicat 124–125 °C, ESCR above 1,000 h – they can usually substitute for each other.
- SCG lists H5604F as bimodal HDPE and reports 139 g dart; HD7000F reports 820 % elongation and 300 kg/cm² (≈29 MPa) tensile.
- The two producers report different properties, so film toughness cannot be compared directly yet – trial on your own line.
Which grade to choose?
- Running one of them and need a backup source: the other is the closest match.
- Choose by price, availability and trial results (toughness, film uniformity).
Tips when switching grades
- Compare like with like: same test method and units (ISO/ASTM; MPa or kg/cm²; Izod or Charpy). Values from different methods are not directly comparable.
- Melt flow has a lot-to-lot tolerance – check the COA of the actual lot, not just the TDS.
- Different additives (nucleating, antistatic, antioxidant, slip) can change the part even when key values match.
- Always trial on your own machine and mold: check temperature, pressure, shrinkage, colour and appearance before switching volume.
FAQ
Can H5604F and HD7000F replace each other?
Usually yes – MI, density and ESCR are almost the same. Trial the first lot to adjust temperature and blow-up ratio.
What does bimodal HDPE bring to thin film?
Bimodal HDPE combines a high-molecular-weight part for strength with a lower one for processing, allowing thin yet tough film.
How does HDPE film differ from LLDPE film?
HDPE film is stiff and crisp and carries load at low gauge; LLDPE film is soft, flexible and more puncture resistant.
Grade pages with TDS downloads: H5604F · HD7000F
Other comparisons: LDPE film grades · LLDPE film grades · HDPE injection grades by melt flow · HDPE pipe grades · HDPE for large blow-molded parts · HDPE for monofilament, nets and tape
Based on producers' public TDS, for technical reference only. For grade advice or a quote, contact Thien An Plastics: +84 389 980 742 (WhatsApp, WeChat, Zalo).