NHỰA THIÊN ANTHIEN AN PLASTICS Request a quote
Knowledge · Grade comparison

General-purpose injection ABS: D-150 (GPPC) vs DG417 (Dagu)

D-150 and DG417 are both medium-impact ABS for injection-molded housings, housewares and toys. One comes from Taiwan, the other from China – where do they differ?

Updated: 17 Nov 2026 · Thien An Plastics

TDS comparison

PropertyD-150
Grand Pacific Petrochemical (Taiwan)
DG417
Dagu Chemical (China)
Melt flow rate (220 °C/10 kg)27 g/10 min20 g/10 min
Density1.05 g/cm³—
Tensile strength at yield48 MPa47 MPa
Flexural modulus2,450 MPa2,265 MPa
Notched Izod impact (23 °C)—200 J/m
HDT (1.8 MPa)88 °C—
Vicat softening point—101 °C
Rockwell hardness (R)110—

Typical values from each producer's TDS, for reference only, not guaranteed specifications. "—" means not stated on the TDS. Values marked "≈" are unit conversions by Thien An for easier comparison.

Key differences

Which grade to choose?

Tips when switching grades

FAQ

Can D-150 and DG417 replace each other?

In many general ABS parts, yes, but D-150 flows about 35 % more, so re-adjust molding conditions and check shrinkage and appearance when switching.

Which is stiffer?

Per TDS, D-150 has the higher flexural modulus (2,450 vs 2,265 MPa).

Are TDS and MSDS available?

Yes. The D-150 page has the TDS; the DG417 page has both TDS and MSDS.

Grade pages with TDS downloads: D-150 · DG417

Other comparisons: PP homopolymer for injection, MFR 12 · PP impact copolymer for injection, MFR 9 · Are "5502" HDPE blow-molding grades from different producers the same? 5502 vs 5502BN vs Q5502BN vs HY55430 · Clear random PP for injection

Based on producers' public TDS, for technical reference only. For grade advice or a quote, contact Thien An Plastics: +84 389 980 742 (WhatsApp, WeChat, Zalo).

Zalo